Lenze 8400 BaseLine C - Load Lenze Setting; Loading Parameter Settings

4 Device control (DCTRL)
4.1 Device commands
48
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.1 Load Lenze setting
The C002/1 = "1: : On / start" device command resets the parameters to the Lenze setting which are
saved in the controller firmware.
• Can only be executed if the controller is inhibited; otherwise, the feedback C002/1
="6: No ac-
cess - controller inhibit" will be returned.
• All parameter changes which have been carried out after the last time the parameter settings
were saved will be lost!
• This device command has an effect on the settings of the parameters of the operating system,
application and module.
 How to load the Lenze setting:
1. If the controller is enabled, it must be inhibited, e.g. by executing the "Enable/Inhibit cont-
roller" device command" (C002/16
="0:Off / ready").
2. Execute the "Load Lenze setting" device command
C002/1
="1:On / start"
The load process may take a couple of seconds. After the device command has been called
in C002/1
a dynamic status information ("Work in progress"  "Off / ready") is returned.
4.1.2 Loading parameter settings
The C002/2 = "1: On / start" device command reloads all parameters from the memory module to
the controller.
• Can only be executed if the controller is inhibited; otherwise, the feedback C002/2
="6: No ac-
cess - controller inhibit" will be returned.
• All parameter changes which have been carried out after the last time the parameter settings
were saved will be lost!
• This device command has an effect on the settings of the parameters of the operating system,
application and module.
 How to reload the starting parameter settings from the memory module:
1. If the controller is enabled, it must be inhibited, e.g. by executing the "Enable/Inhibit cont-
roller" device command (C002/16
="0:Off / ready").
2. Execute the "Load Lenze setting" device command:
C002/2
="1:On / start"
The load process may take a couple of seconds. After the device command has been called
in C002/2
2 a dynamic status information ("Work in progress"  "Off / ready") is returned.
 Note!
When the device is switched on, all parameters are automatically loaded from the me-
mory module to the main memory of the controller.