Lenze 8400 BaseLine C - LED Status Display

2 Introduction: Parameterising the controller
2.3 Internal Keypad
18
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Control elements
2.3.2 LED status display
Key Name Function
ESC Escape key On menu and parameter level: Back
In case of parameter processing: Abort (discard changed setting)
↵ Enter key On menu and parameter level: Next (confirm selection)
In case of parameter processing: OK (accept changed setting)
Long pressing (3 seconds): Saving of all parameters
Quick saving of all parameters at the push of a button
( 23)
 Navigation key
upwards
On menu and parameter level: Navigation
In case of parameter processing: Set parameter value
Long pressing (> 2 seconds): Quick scroll function
 Navigation key
downwards
Information on some operating states can quickly be ob-
tained via the front D and E LEDs:
The meaning can be seen from the table below.
E
"DRIVE READY"
D
"DRIVE ERROR"
Description Device state
(Display in C137
)
OFF OFF OFF or initialisation active Init
OFF Safe torque off is active SafeTorqueOff
OFF Device is ready to start ReadyToSwitchON
OFF Device is switched on SwitchedON
OFF Motor data identification/operation OperationEnabled
The controller is ready to switch on, switched
on or the operation is enabled and a warning
is indicated.
OFF Trouble is active Trouble
OFF Fault is active Fault
Legend
The symbols used for indicating the LED states have the following meaning:
LED is flashing once approx. every 3 seconds (slow flash)
LED is flashing once approx. every 1.25 seconds (flash)
LED is flashing twice approx. every 1.25 seconds (double flash)
LED is blinking every second
LED is permanently on
8888
B
C
D
E
F
A