Lenze 9300 vector - Page 313

Configuration
Code table
8
8.5

8.5−24
EDSVF9383V EN 4.0−03/2006
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0358 Reset node 0
0 No function
Set the nodal reset pointof the
system bus
1 CAN reset
C0359 CAN state
0 Operational
System bus status
l Read only
1 Pre−operational
2 Warning
3 Bus off
C0360 0 65535 Telegram counter
l Read only
l For count values > 65535 the
counter starts at 0
1 Message OUT All telegrams sent
2 Message IN All telegrams received
3 Message
OUT1
Telegrams sent on CAN−OUT1
4 Message
OUT2
Telegrams sent on CAN−OUT2
5 Message
OUT3
Telegrams sent on CAN−OUT3
6 Message
POUT1
Telegrams sent on parameter
channel1
7 Message
POUT2
Telegrams sent on parameter
channel2
8 Message IN1 Telegrams received from
CAN−IN1
9 Message IN2 Telegrams received from
CAN−IN2
10 Message IN3 Telegrams received from
CAN−IN3
11 Message PIN1 Telegrams received from
parameter channel1
12 Message PIN2 Telegrams received from
parameter channel2
efesotomasyon.com - Lenze