Lenze EVF9324

Commissioning
Contents
6

6-1
EDSVF9333V EN 3.0-06/2005
6 Commissioning
Contents
6.1 Before switching on 6.1-1..............................................
6.2 Selection of the control mode 6.2-1......................................
6.3 Parameter setting with the XT EMZ9371BC keypad 6.3-1....................
6.3.1 Commissioning example in V/f characteristic control mode 6.3-1.....
6.3.2 Commissioning example in vector control mode 6.3-5...............
6.4 Controller inhibit 6.4-1.................................................
6.5 Changing the assignment of the control terminals X5 and X6 6.5-1...........
6.5.1 Free configuration of digital input signals 6.5-1....................
6.5.2 Free configuration of digital outputs 6.5-3........................
6.5.3 Free configuration of analog input signals 6.5-4....................
6.5.4 Free configuration of analog outputs 6.5-6........................
6.6 Adjusting the motor 6.6-1..............................................
6.6.1 Entry of motor data 6.6-1.......................................
6.6.2 Motor selection list 6.6-4.......................................
6.6.3 Motor temperature monitoring with PTC or thermal contact 6.6-8....
6.6.4 Motor temperature monitoring with KTY 6.6-10.....................
6.6.5 Current limits 6.6-12...........................................
6.6.6 Automatic collection of motor data 6.6-13..........................
6.7 Setting the speed feedback 6.7-1........................................
6.7.1 Incremental encoder with TTL level at X8 6.7-2.....................
6.7.2 Incremental encoder with HTL level at X9 6.7-2.....................
6.8 Operating mode 6.8-1.................................................
6.8.1 V/f characteristic control 6.8-4..................................
6.8.2 Vector control 6.8-8...........................................
6.9 Switching frequency of the inverter 6.9-1.................................
6.10 Acceleration, deceleration, braking, stopping 6.10-1.........................
6.10.1 Speed range 6.10-1.............................................
6.10.2 Setting acceleration times and deceleration times in speed mode 6.10-3
6.10.3 Quick stop 6.10-4...............................................
6.10.4 Changing the direction of rotation 6.10-5..........................
6.11 Optimising the operating behaviour 6.11-1................................
6.11.1 Slip compensation 6.11-1........................................
6.11.2 Oscillation damping 6.11-3......................................
6.11.3 Boost c orrection with V/f characteristic control 6.11-5................
6.11.4 Motor magnetising current with vector control 6.11-9................