Commissioning
Operating mode
6
6.8
6.8-1
EDSVF9333V EN 3.0-06/2005
6.8 Operating mode
The control mode of the controller can be selected via the operating mode.
You can select between the following modes:
ƒ V/f characteristic control
ƒ Vector control
The V/f characteristic control is the classic operating mode for standard
applications.
When using the vector control you will achieve improved drive features
compared to the V/f characteristic control due to:
ƒHighertorqueviathecompletespeedrange
ƒ Higher speed accuracy and higher concentricity factor
ƒ Higher efficiency
Description
Selection of the correct
operating mode
To Next Page
Loading...