Leuze electronic BCL 8 S 2 Series - Connector Unit MA 8-01; Figure 5.2: Pin Assignment MA 8-01

Accessories / Order Designation
26 BCL 8 Leuze electronic
5.3 Connector unit MA 8-01
The modular connector unit is an optional accessory when connecting a BCL 8 to an RS 485
interface. The RS 485 interface, the switching input and the switching output are all
connected to the MA 8-01. It also supplies voltage to the BCL 8. The MA 8-01 connector unit
offers the following advantages over the installation of the BCL 8 as a stand-alone device:
• M12 socket for switching input and switching output
• M12 connector for RS 485 interface and voltage supply 24VDC
• M12 socket for connection of the BCL 8
Figure 5.2: Pin assignment MA 8-01
Attention!
Protection class IP 67 is achieved only if the connectors and caps are screwed into place!
PWR IN HOST/RS 485 = Voltage supply/RS 485 host interface
SW IN/OUT = Switching input/output
BPS = Connection to BCL 8/BPS 8
Notice!
The SW IN/OUT connection is sealed with a thread plug upon delivery.
All dimensions in mm
1
23
4
5
RXD VIN
GND
SWIN/SWOUT
TXD
1
23
4
5
SWIN VOUT
GND
FE
SWOUT
3
21
4
5
A (P) GND
VIN
FE
B (N)
BPS SW IN/OUT
PWR IN
HOST/RS485
M12 socket
(A-coded)
M12 socket
(A-coded)
M12 plug
(A-coded)