Online commands
58 BCL 8 Leuze electronic
11.1.1 General 'online' commands
Software version number
Notice!
You can use this command to check whether the communication to the connected computer
is functional. If you do not receive an acknowledgement, please check the interface connec-
tions or the protocol.
Software reset
Command ’V’
Description Requests device version information
Parameter None
Acknowledg-
ment
Ex.: ’BCL 8 V 01.10 05.10.2006’
The device type appears in the first line followed by the device's version
number and date. The data which is actually displayed may vary from the
values given here.
Command ’H’
Description
Carries out a software reset. The device is restarted and reinitialized, leav-
ing it in the same state as when the supply voltage is switched on.
Parameter No
Acknowledg-
ment
’S’ (start signal)
To Next Page
Loading...
