Important Parameters
Leuze electronic BCL 8 49
TNT 35/7-24V
10.3 Control tab
Figure 10.4: Control tab
Activation
Switching input 1
function
See menu "switching input"
Autostart after
decoding
In this mode, the scanner reads via an internal trigger signal with max-
imum performance. Attention: Up to 100 codes per second may be
transmitted.
Command
character
The standard online character for the trigger start is the ´+´ character.
This character can be changed only via the tree structure.
Decode delay time
This point is usually used only for test purposes. After the time set
here has passed, the scanner automatically reactivates itself following
a reading gate end (e.g. in combination with "Autostart after decod-
ing").
To Next Page
Loading...
