Leuze electronic BPS 307i - Page 55

Basic configuration
Leuze electronic BPS 307i 55
1 Slide switch S1
Factory setting: Gray encoding
2 Hexadecimal rotary switch S2
Factory setting: switch position
0 , i.e., configuration via webConfig tool
Figure 8.3: Operational controls of connection hood MK 307
Slide switch S1
Change the measurement value encoding
• S1 up: Gray encoding
• S1 down: binary encoding
Rotary switch S2
Table 8.1: Configuration via rotary switch S2
NOTICE
Hexadecimal rotary switch S2 for setting the resolution and speed monitoring!
 Set the resolution of the position measurement and speed monitoring via rotary switch S2.
1 2
Switch position Position resolution
[mm]
Maximum speed
[m/s]
Level of the switch-
ing output
Speed monitoring
0 Configuration via webConfig tool
1 0.01 webConfig webConfig webConfig
2 0.1 webConfig webConfig webConfig
3 1 webConfig webConfig webConfig
4 10 webConfig webConfig webConfig
5 webConfig webConfig webConfig webConfig
6 webConfig webConfig webConfig webConfig