Leuze electronic BPS 307i - Orientation of the BPS to the Bar Code Tape; Mounting with the BTU 0300 M-W Mounting Device

Mounting and installation
Leuze electronic BPS 307i 40
6.2.2 Orientation of the BPS to the bar code tape
The beam of the BPS must be oriented at an incline of 7° to the bar code tape (see figure 6.9). When posi-
tioning, make certain that the angle of radiation to the rear side of the housing is 90 ° and the reading
distance to the bar code tape is maintained.
1 Reading distance
2 Reference point for the bar code position
3 Scanning beam
Figure 6.9: Beam exit
6.2.3 Mounting with the BTU 0300M-W mounting device
Mounting the BPS with a BTU 0300M-W mounting device is intended for wall mounting. For ordering infor-
mation see chapter 14; for dimensioned drawing see figure 13.9.
0000
4
0
0000
4
4
0000
4
8
00005
2
000056
00006
0
00006
4
00006
8
1
3
2
2
50