Removing optional cards
115
Administration
3 Holding the card by its sides, gently pull it straight out from the system board. If the card does
not come out easily, turn the top edge of the card away slightly and then toward the system
board several times as you pull gently and evenly on both sides.
Note: Avoid touching the metal pins on the bottom of the card.
4 Place the optional firmware or flash memory card in its original packaging, or wrap it in paper
and store it in a box for protection.
5 If you need to install another optional firmware or flash memory card on the system board,
refer to the Setup Guide.
6 Replace the system board. See Replacing the system board.
To Next Page
Loading...
