Lexmark C510 - Setting the Operator Panel When a Supply Is Replaced; Changing the Toner Cartridge Yield; Specifying the Replaced Supply

Setting the operator panel when a supply is replaced
77
Maintenance
Setting the operator panel when a supply is replaced
If you plan to replace a toner cartridge and the toner cartridge you are replacing has a different part
number, you must change the toner cartridge yield setting before installing the toner cartridge.
Changing this setting is necessary to maintain the accuracy of the counter in showing the remaining
toner. See Changing the toner cartridge yield for instructions.
When you replace a supply item, you must specify which item was replaced. See Specifying the
replaced supply for instructions.
Changing the toner cartridge yield
Change the yield setting before you install the toner cartridge.
1 Make sure the printer is on and the Ready message appears.
2 Press and release Menu until you see Config Menu, and then press Select.
3 Press and release Menu until you see Cartridge Yield, and then press Select.
4 Press and release Menu until you see the color name of the toner cartridge you need to
replace. The selections are Cyan, Magenta, Yellow, and Black. Press Select.
5 Press and release Menu until you see the type of the toner cartridge you need to replace. The
selections are Standard Yield and High Yield. Press Select.
6 Press Menu until you see Exit Config Menus, and then press Select.
The change to the yield setting takes effect once you exit the Config Menu.
7 Install the toner cartridge. See Replacing the toner cartridges for instructions.
8 Specify the item you replaced. See Specifying the replaced supply for instructions.
Specifying the replaced supply
Note: If you replace the fuser or photodeveloper cartridge once the printer issues the
87 Fuser Life Warning or 83 Photodev Cart Life Warning messages,
respectively, the printer issues message prompts on the operator panel for you to
follow. You need to follow those printer message prompts instead of completing the
following instructions.
Once you have replaced a toner cartridge, a fuser, or a photodeveloper cartridge, complete the
following:
1 Make sure the printer is on and the Ready message appears.
2 Press and release Menu until you see Supplies Menu, and then press Select.
3 Press and release Menu until you see Replace Supplies, and then press Select.