Using the media support in the output bin
47
Media specifications
Using the media support in the output bin
Use the media support so a stack of media does not skew in the output bin. To use the media
support:
1 Grasp the edge of the media support at the indentation in the output bin.
2 Lift the media support. Pull the tab on the bottom of the media support forward until it snaps
into place.
3 Lower the media support into place so that it is now at an angle due to the tab.
The media support is inclined so your stacked media now remains in a neater stack in the output bin.
Note: Do not leave the media support inclined if you are printing transparencies.
Indentation
Tab
Media support
To Next Page
Loading...
