Config Menu
137
Using printer menus
Config Menu
To gain access to the Config Menu, you must press and hold the Select and Return buttons as you
turn the printer on. The Configuration Menu contains a set of menus, settings, and operations which
are infrequently required, but beneficial to you.
Toner
Darkness
To lighten or darken printed output, or
conserve toner.
Setting Toner Darkness to values of 1,
2, or 3 is only effective when using the
PostScript driver.
5
4*
Either setting gives you the
maximum expenditure in toner
consumption; however, 4 is the
default toner darkness setting
since only one could be the
default.
3 Reduction in toner
consumption.
2 Further reduction in toner
consumption.
1 Maximum reduction in toner
consumption.
Menu Item Purpose Values
Auto Size
Sense
To set tray 1 into a non-auto size
sensing mode. This enables the
printer to print media sizes not
specifically supported by any of the
trays, such as envelope sizes other
than 10 and DL. It also allows the
Universal setting.
Tray1 Auto Size
Auto Sets auto size sensing on.
Off Sets auto size sensing off.
Prt Quality
Pgs
To print the Printer Quality Test
Pages which help isolate print
quality problems by looking at the
text and graphics on the pages.
No selections exist for this operation.
Press Select to initiate the operation.
For more complete instructions, see Printing the
Print Quality Test Pages.
Tray Insert
Msg
Indicates the delay in seconds for
how long it takes for the Insert
Tray <x> message to appear on
the operator panel once a tray is
removed from the printer or
support unit. x represents the
number of the tray.
Disabled Disables the tray insert
message.
1 – 90 (5*) Specifies the number of
seconds that pass before the
Insert Tray <x> message
appears on the operator
panel.
Menu Item Purpose Values
To Next Page
Loading...
