Lexmark C510 - Adjusting Power Saver; Configuring Printer Alerts; Using the Setup Menu

Adjusting Power Saver
97
Administration
Adjusting Power Saver
To adjust the Power Saver setting in the Setup Menu:
1 Press Menu until you see Setup Menu, and then press Select.
2 Press Menu until you see Power Saver, and then press Select.
3 Press Menu until you see the desired number of minutes and then press Select. Minute
settings available range from 1–240. If needed, the menu value Disabled is also available.
Note: You can also adjust the Power Saver setting by issuing a Printer Job Language
(PJL) command. For more information, refer to the Technical Reference available
on our Lexmark Web site at www.lexmark.com.
Configuring printer alerts
You can configure the printer several ways to let you know when it requires attention.
Using the Setup Menu
Selecting Auto Continue may affect how the printer alerts execute. This setting defines how long
the printer waits after displaying a message before it resumes printing.
Menu item Function Value Result
Alarm
Control
Lets you establish whether the
printer sounds an alarm when
it requires operator
intervention.
Off The alarm does not sound, but printing
stops until the interventions are
cleared.*
Single The printer stops printing, displays a
message, and activates the selected
alarm type.
Continuous
Toner Alarm Lets you choose how the
printer responds when toner is
low.
Off The printer displays a message and
continues printing.
Single The printer stops printing, displays a
message, and activates the selected
alarm type.
Continuous
* If multiple attendance conditions are pending, the alarm only sounds when the first message is displayed.
No additional alarms sound as subsequent attendance conditions arise.