Lexmark C510 - Page 138

Config Menu
138
Using printer menus
Panel Menus This menu item is only displayed
when the PJL Password
Environment variable is set to zero.
For information about PJL
commands, refer to the Tech nical
Reference.
Note: The system administrator
may want to disable the operator
panel menus so other users do not
make changes to the menu item
selections. All menu selections are
disabled.
Note: Disabling the operator panel
menus does not prevent access to
the Job Menu or to Print and Hold
functionality.
Disable For complete instructions, see
Disabling operator panel
menus.
Enable*
Download Emuls This menu item is only displayed if
at least one Downloaded Emulator
is installed.
Disable Disables the download
emulator.
Factory
Defaults
Lets you to restore the network
settings or the base printer settings
to their factory default values.
The Restoring Factory
Defaults message is displayed
once one of the values is selected.
Restore Base Restores non-critical base
printer NVRAM settings.
This value is only listed on
printer models that have
integrated network support.
Restores all network NVRAM
settings to their factory default
values. This is only available
on printers with an integrated
network adapter.
Restore Network
Energy
Conserve
This setting only affects the values
that are displayed in the Power
Saver menu item in the Setup
Menu.
On* If set to On, then Disabled
does not appear as a value in
the Power Saver menu item.
Off If set to Off, then Disabled
appears as a value in the
Power Saver menu item.
Font
Sharpening
Lets you set the threshold for
switching between font sharpening
screens and normal screens. This
applies only to PostScript fonts.
1–150 (24*) For example, if the value is set
to 75, then all fonts 75 points
and smaller are sharpened.
Fonts larger than 75 points
are not sharpened. If the
value is set to 102, then all
fonts 102 points and smaller
are sharpened. Fonts larger
than 102 points are not
sharpened.
Menu Item Purpose Values