Lexmark X203N - Unacceptable Paper Types List

Diagnostic information 2-15
7011-2xx
80B Too many errors when transmitting in
ECM mode.
• Check line quality.
• Adjust ‘Transmit Level’.
• Select a lower ‘Max Speed’value under
Fax Send setting’s.
80C Remote device failed to respond to the
CTC command.
• Select a lower ‘Max Speed’ value
under Fax Send setting’s.
• Adjust ‘Transmit Level’.
80D Received too many requests from
remote end to repeat the previous
command sent.
• Check line quality.
• Adjust ‘Transmit Level’.
• Check if line conditions on remote end
will facilitate a good connection.
80E Functional limitation- Remote fax
device does not support G3 receive
capability.
No action needed. Issue with the remote
device.
811 Failed to detect a fax device at the
remote end.
• Verify MFD is answering to fax call and
not a voice call.
• Decrease value of ‘Rings To Answer’
setting.
812 No more data rates available in V34
modulation scheme.
• Adjust to a lower modulation scheme.
813 Timeout occurred after waiting too long
to receive a good frame.
• Adjust “Receive Threshold”.
814 Tried too many times at selected speed
using V34 modulation scheme.
• Adjust ‘Transmit Level’.
• Adjust to a lower modulation scheme.
815 Fax transmission was interrupted due
to power failure.
• Troubleshoot MFP if error persists. See
“Modem service check” on
page 2-29.
818 Fax transmission failed due to
insufficient memory to store scanned
image.
Adjust ‘Memory Use’ setting to allocate
more memory for send jobs.
819 Fax transmission failed due to
insufficient memory to store received
image.
Adjust ‘Memory Use’ setting to allocate
more memory for receive jobs.
81A A timeout occurred during transmission
of a page in ECM mode.
Select a lower ‘Max Speed’ value under
Fax Send setting’s.
880 Failure to transmit training successfully
in V17, V29, V27 terminal modulation
schemes.
• Select a lower “Max Speed” under Fax
Send setting’s.
• Adjust the “Transmit Level”.
• Check line quality.
882 Failure to transmit training successfully
in V17, V29 terminal modulation
schemes.
• Select a lower “Max Speed” under Fax
Send setting’s.
• Adjust the “Transmit Level”.
• Check line quality.
883 Failure to transmit training successfully
in V17,V27 terminal modulation
schemes.
• Select a lower “Max Speed” under Fax
Send setting’s.
• Adjust the “Transmit Level”.
• Check line quality.
Fax error log codes (Continued)
Error code Description Action