2-16 Service Manual
7011-2xx
884 Failure to transmit training successfully
in V29, V27 terminal modulation
schemes.
• Select a lower “Max Speed” under Fax
Send setting’s.
• Adjust the “Transmit Level”.
• Check line quality.
885 Failure to transmit training successfully
in V17terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send setting’s.
• Adjust the “Transmit Level”.
• Check line quality.
886 Failure to transmit training successfully
in V29 terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send setting’s.
• Adjust the “Transmit Level”.
• Check line quality.
887 Failure to transmit training successfully
in V27 terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send setting’s.
• Adjust the “Transmit Level”.
• Check line quality.
888 Failure to transmit training successfully
at 2400 bps in V27 terminal modulation
scheme.
• Adjust “Transmit Level”.
• Check line quality.
889 Failed to connect at the minimum
speed supported by the MFP.
• Adjust “Transmit Level”.
• Incompatible connection.
88A Failed to connect using V.34
modulation scheme.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
901 No fax tones detected from remote
end.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
902 No dial tone detected. • Check by enabling ‘Behind a PABX’
setting.
• Check phone line.
• Check MFD modem hardware.
903 Busy tone detected. Check with remote end if successive
attempts fail.
904 Hardware error detected. See “Modem service check” on
page 2-29.
905 A timeout occurred after dialing the
number and waiting for a response.
Check with remote end if successive
attempts fail.
906 Fax canceled by user. No action needed.
907 Modem detected a digital line
connection.
Verify the MFP is connected to an analog
line. See“Fax transmission service
check” on page 2-44.
908 Phone line was disconnected Restore phone line connection.
A00 Received request for unsupported
function from remote fax device.
No action needed.
Fax error log codes (Continued)
Error code Description Action
To Next Page
Loading...
