29
Load media
6 Place the print media against the
left side of the tray, with the print
side down and facing the front of
the tray.
Do not load bent or wrinkled print
media.
7 Tuck the corner of the print media
under the metal stop.
Note: Overfilling the tray may cause jams. Refer to the
table on page 25 for the maximum capacity of various
print media in the tray.
8 Squeeze the width guide tab and
the width guide together and slide
the width guide until it lightly
touches the stack of print media.
9 Squeeze the length guide tab and
the length guide together, and then
slide the guide to the edge of the
print media.
Metal stop
Stack
height
indicator
To Next Page
Loading...
