Lexmark X422 - Step 10: Configure for TCP;IP; Assigning an MFP IP Address

41
Configure for TCP/IP
Step 10: Configure for TCP/IP
If you have TCP/IP available on your network, we recommend that you
assign an IP address to the MFP.
Assigning an MFP
IP address
If your network is using DHCP, an IP address is automatically assigned
after you connect the network cable to the MFP.
1 Look for the address under the “TCP/IP” heading on the
network setup page you printed in “Printing a network
setup page” on page 44.
2 Go to “Verifying the IP settings” on page 42 and begin with
step 2.
If your network is not using DHCP, then you must manually assign an
IP address to the MFP.
An easy way to do this is to use the MFP control panel:
1 Press the administration button and then select Network/USB
and then TCP/IP.
2 Change the address by entering the new IP address in the
Address field using the numeric keypad. Use the arrow keys to
navigate the IP address fields.
3 Enter the appropriate address in the Netmask field using the
arrow keys to navigate.
4 Enter the appropriate address in the Gateway field using the
arrow keys to navigate.
5 When you are finished, select Submit to return the MFP to the
Ready state.
6 Reprint the network setup page to see the new configuration.
See “Printing a network setup page” on page 44.
7 Go to “Verifying the IP settings” on page 42.