17
Install optional memory cards
Reattaching the system board
access shield
1 Align the six keyholes on the shield
with the six screws on the system
board.
2 Press the shield against the
system board, and then slide the
shield to the right.
3 Tighten the six screws.
Reattaching the side door
1 Align the three rear tabs on the
side door with the corresponding
slots on the MFP.
2 Guide the tabs on the top, bottom,
and front of the door into their
corresponding slots. The top and
front tabs snap into place.
3 Close the upper front door and the
multipurpose feeder door. Make
sure both doors snap closed on
both sides.
To Next Page
Loading...
