33
Load media
Loading envelopes
1 Make sure the multipurpose
feeder is only pulled out and not
extended.
2 Place the envelopes against the
left side of the multipurpose
feeder, with the print side up and
the stamp corner on the right side.
3 Push the envelopes forward, but
do not force them.
Note: If you are loading envelopes into the multipurpose
feeder, do not extend the tray all of the way. This may
cause envelopes to feed incorrectly.
4 Slide the width guide until it lightly
touches the stack of envelopes.
To Next Page
Loading...
