FILM & 2:2 PULLDOWN indicator LEDs
PASSTHRU indicator LED
LCD Display
The LCD display has 2 distinct modes see Section 6 for further details:
Status Display
By default, the LCD displays the current status of Leadshow 3G,
which includes the following information:
Input source format
Image aspect ratio
Overscan
Gamma type
Primary output port
Output resolution
Deinterlacing mode
Setup Display
When you are setting up Leadshow 3G , the LCD display shows the setup menu Typical operation
includes:
To enter menu set up mode, press [OK]
To highlight the previous or next item, press [UP] or [DOWN]
To increase or decrease value, press [LEFT] or [RIGHT]
To select an item or confirm setting, press [OK]
To exit and go up one level of the menu, press [BACK]
Infra Red (IR) input sensor
Film 2:2 Pulldown Mode
OFF OFF Video (Motion Adaptive Deinterlacing)
ON OFF Film (3:2 Pulldown)
ON ON Film (2:2 Pulldown)
OFF ON Not applicable
8
9
10
11
12
To Next Page
Loading...