Leyard Leadshow 3G - Output Port Configuration When in Passthru Mode

To Next Page

To Previous Page

If the Analog output is configured as YPbPr, the OSD turns to the following page:

7.7.4 OUTPUT PORT CONFIGURATION WHEN IN PASSTHRU MODE

 Passthru from SDI and analog input is available only in firmware version 2.00 or later

 Passthru to Analog output is available only in firmware version 2.00 or later

This option defines the characteristics of output ports when in Passthru mode.

 You can define the format of the HDMI output, which include:

 Color Space

 Output Level

 Sync Polarity

 You can also define the characteristics of the analog output port, which include:

 Color Space

 Sync Polarities

 Voltage Pump

 Those formats can also be Same as Input, besides the fixed options. The following table

lists exactly what the output color space is if defined as Same as Input:

tuptuOgolanAtuptuOIMDHtupnI

HDMI RGB RGB RGBHV

HDMI YCbCr 4:2:2 YCbCr 4:2:2 YPbPr

HDMI YCbCr 4:4:4 YCbCr 4:4:4 YPbPr

rPbPY2:2:4rCbCYIDS

Analog RGBS RGB RGBS

Analog RGsB or RGBHV RGB RGBHV

Analog YPbPr YCbCr 4:2:2 YPbPr

S-Video YCbCr 4:2:2 YPbPr

Composite YCbCr 4:2:2 YPbPr