155
INSTALLER SETTING
ENGLISH
Service - Pump test run
'Test run' will activate the Main pump for 1 hour. During this period, the pump will be turned on
and off intermittently to purge air from the cycle.
Based on setting 'Configuration/External pump', the External pump will be activated, too.
The operation can be stopped by pushing the On/Off button on the Remote controller.
Service - Actuator test - Test mode
Service - Actuator test - Pump test
Service - Actuator test - Valve test
'Test run' will activate the Main pump for 1 hour. During this period, the pump will be turned on
and off intermittently to purge air from the cycle.
Based on setting 'Configuration/External pump', the External pump will be activated, too.
The operation can be stopped by pushing the On/Off button on the Remote controller.
NOTE
The settings for Dry contact should be disabled to use the Pump test run function.
Connectivity - Dry contact - CN-CC = D/C Not installed
Connectivity - CN_EXT = Not use
After finishing the Test run, make sure to change back to previous settings.
NOTE
The settings for Dry contact should be disabled to use the Actuator test function.
Connectivity - Dry contact - CN-CC = D/C Not installed
Connectivity - CN_EXT = Not use
After finishing the Actuator test, make sure to change back to previous settings.
To Next Page
Loading...
Need help?
General