39
INSTALLATION OF OUTDOOR UNIT
ENGLISH
Selecting the location(Outdoor Unit)
- If the outdoor unit is to be installed close to the seaside, direct exposure to the sea wind should
be avoided. Install the outdoor unit on the opposite side of the sea wind direction.
- It should be strong enough like concrete to prevent the sea wind from the sea.
- The height and width should be more than 150% of the outdoor unit.
- It should be keep more than 700 mm of space between outdoor unit and the windbreak for
easy air flow.
- Select a well-drained place. Periodic (more than once/year) cleaning of the dust or salt particles
stuck on the heat exchanger by using water.
- If you can’t meet above guide line in the seaside installation, please contact your supplier for the
additional anti-corrosion treatment.
- In case, to install the outdoor unit on the seaside, set up a windbreak not to be exposed to the
sea wind.
Installation at Seaside
CAUTION
!
• Unit should not be installed in areas where corrosive gases, such as acid or alkaline gas, are
produced.
• Do not install the product where it could be exposed to sea wind (salty wind) directly. It can
result corrosion on the product. Corrosion, particularly on the condenser and evaporator fins,
could cause product malfunction or inefficient performance.
• If outdoor unit is installed close to the seaside, it should avoid direct exposure to the sea
wind. Otherwise it needs additional anti-corrosion treatment on the heat exchanger.
To Next Page
Loading...
Need help?
General