91
USER SETTING
90
USER SETTING
ENGLISH
Screen saver timer setting
Adjust the screen Off time of the remote controller.
• Select the following setting values using [<,>(left/right)] button.
LCD brightness in idle setting
Adjust the remote controller’s screen brightness.
• Select the following setting values using [<,>(left/right)] button.
CAUTION
Selecting brighter stand by screen will decrease LCD lifespan.
※ "Auto" setting is only available in the indoor units that is equipped with the human detection
sensor.
※ When set to Auto, wired remote standby screen brightness (0%, 10%, 20%, 30%) will auto-
matically adjust according to the illuminance detected by the human detection sensor.
!
Value
15sec 30sec (default) 1min
CAUTION
Selecting longer stand by screen will decrease LCD lifespan.
!
Value
0% 10% (default) 20% 30% Auto
Temperature unit setting
Set the temperature unit displayed on the remote controller.
• In the user setting list, select the temperature unit setting category, and press [OK] button to
move to the detail screen.
Value
Celsius
1°C
0.5°C
Fahrenheit
OK
CAUTION
The temperature unit function may not work or work differently in some products.
You cannot set the temperature unit in the slave wired remote controller.
!
To Next Page
Loading...
