141
INSTALLER SETTING
140
INSTALLER SETTING
ENGLISH
Indoor unit Auto-Start setting (air conditioner / DX ventilator)
It is a function that sets whether to restore the indoor unit operation by resuming the previous
power-on state or as power-off state in the power failure compensation.
• You can set the following setting values using [<,>(left/right)] button.
Value Description
Use Use indoor unit auto restart
Not use Not use indoor unit auto restart
Occupancy duration time setting(air conditioner)
It is a function that sets the light-on/occupancy duration after motion is detected when installing
an occupancy sensor.
• You can set the following setting values using [<,>(left/right)] button.
Value
0 Minute
10 Minutes
30 Minutes
60 Minutes
To Next Page
Loading...
