4. Operation HDMI-TPS-RX110AY – User's Manual 18
4
Operation
This chapter is about the powering and operating of the device describing the
Î
Î
Action or an operation can be assigned to the Function button.
Event Manager. See more details in the Event Manager section.
The device gets a static IP address as a factory default setting. If this
can be enabled from the front panel:
Step 1. Make sure the device is powered on and operational.
Step 2. Press and keep pressed the Function button for 5 seconds.
Step 3.
button and press it 3 times again quickly (within 3 seconds).
Step 4.
To restore factory default values, do the following steps:
Step 1. Make sure the device is powered on and operational.
Step 2. Press and keep pressed the Function button for 10 seconds.
pressing the button.
Step 3. After 10 seconds the blinking gets faster; release the button
and press it 3 times again quickly (within 3 seconds).
Step 4.
settings and reboots.
Factory default settings are listed in the Factory Default Settings
section.
FUNCTION
FUNCTION
FUNCTION
Reseting the Device
Pushing the reset button results the same as you disconnect and reconnect
the power adaptor to the receiver. To reseting the device follow the steps:
Step 1. Push the button with a thin object for a second.
Step 2.
ATTENTION! Reseting the device does not reset the settings to factory
defaults. To reset factory default settings see previous section.
Entering Bootload Mode
as the device cannot be switched to bootload mode automatically. In
this case, receiver device can be forced to switch to bootload mode
as follows:
Step 1. Make sure the transmitter is powered off.
Step 2. Press and keep pressed the Function button.
Step 3. Power on the receiver. If the device is switched to bootload
Software Control Modes
User has more possibilities to control the device besides the front
panel buttons. The following list contains the software control modes:
▪ Lightware Device Controller (LDC): you can connect to the device via
our control software with using USB, RS-232 or Ethernet interfaces
the chapter.
▪ LW2 protocol commands
see the chapter.
▪ LW3 protocol commands
see the chapter.
RESET
FUNCTION
To Next Page
Loading...
Need help?
General
