Lightware HDMI-TPS-RX110AY - Query the Firmware Version; Resetting the Device; Restore the Factory Default Settings; Query the Serial Number

 HDMI-TPS-RX110AY – User's Manual 49
System Commands


Command format: GET●
Response format: pr●
Example:
˃ GET /.ProductName
˂ pr /.ProductName=HDMI-TPS-RX110AY
Set the Device Label
ATTENTION! The device label can be changed to a custom text in the Status software. This
writable parameter is not the same as the ProductName parameter.
Command format: SET●
Response format: pw●

Example:
˃ SET /MANAGEMENT/UID.DeviceLabel=RX110_Conference1
˂ pw /MANAGEMENT/UID.DeviceLabel=RX110_Conference1

Command format: GET●
Response format: pr●
Example:
˃ GET /.SerialNumber
˂ pr /.SerialNumber=87654321

Command format: GET●
Response format: pr●
˃ GET /SYS/MB.FirmwareVersion
˂ pr /SYS/MB.FirmwareVersion=1.0.0b3
Resetting the Device

Command format: ●
Response format: mO●
Example:
˃ CALL /SYS:reset()
˂ mO /SYS:reset=

Command format: ●
Response format: mO●
Example:
˃ CALL /SYS:factoryDefaults()
˂ mO /SYS:factoryDefaults=
The device is restarted, current connections are terminated, and the default settings are restored. See the
complete list in the Factory Default Settings section.



