Lightware UCX Series - Page 83

 UCX series – User's Manual 83

Set Port Power Role
ç SET·<usb-c_port>.PortPowerRoleSetting=<power_role>
EDID Management

ç 

ç 

ç <user_edid>.PreferredResolution
Emulating an EDID to an Input Port
ç <source>:<destination>)
Emulating an EDID to All Input Ports
ç <source>)
Copy an EDID to User Memory
ç <source>:<destination>)
Deleting an EDID from User Memory
ç <user_edid>)
Resetting the Emulated EDIDs
ç 

Set the DHCP State
ç <dhcp_status>
Change the IP Address (Static)
ç <IP_address>
Change the Subnet Mask (Static)
ç <netmask>
Change the Gateway Address (Static)
ç <gw_address>
Apply Network Settings
ç 


ç <port>.Direction
Setting the Direction of a GPIO Pin
ç <port>.Direction(<dir>)

ç <port>.Output

ç <port>.Output(<value>)

ç <port>:interval(<value>;<time>)

ç <port>:toggle()


ç 
Set the Sensor Type
ç <sensor_type>

ç 



