Linde 1202 Series - Lubricating the Sideshifter (Optional Equipment); Check Washer Fluid Level (Optional Equipment)

Lubricating the Sideshifter (op-
tional equipment)
 Check cylinders and fittings for leakage and
have repairs made as necessary.
 Clean the sideshifter according to the sec-
tion "Cleaning the Truck".
 Check hydraulic hoses for abrasion.
 Adjust the forks so that the lower grease
fittings (1) and the grease fittings on the top
rail (2) are accessible.
 Lower the mast fully so the forks are rest-
ing on the ground to unload the sideshifter
bearings.
 Lubricate the sideshifter at all of the grease
fittings.
NOTE
The sideshifter must always be lubricated after
any cleaning.
Check Washer Fluid Level (op-
tional equipment)
If the truck is equipped with an optional wip-
er/washer system for any glazing, then the
washer fluid level will need to be replenished
occasionally.
 Open the hood.
 Open the filler cap (1) on the filler neck (2)
in the left-hand side of the engine compart-
ment.
 Top up with washer fluid until the washer
fluid is visible in the filling opening.
 Close the filler cap.
 Close the hood.
1
1
2
d3931430

1
2
t12020031a

5
Maintenance
Routine Lubrication and Inspection
252 Operating Instructions-1202 series LP 12028011590US-11/2022 - 04