Fastening the seat belt
Pull the seat belt (2) smoothly from the re-
tractor (3) on the left.
Position belt over lap, not over stomach.
Ensure that buckle (1) snaps into place in
the receiver (4).
Check seat belt tension.
Observe the display unit. The seat belt in-
dicator (6) in the status bar should go out
when the seat belt is correctly fastened.
The seat belt must fit close to the body.
Releasing the seat belt
While holding the buckle, press red button
(5) on the receiver(4).
Hold onto the buckle (1) and slowly allow it
to retract into the retractor (3). Do not allow
the buckle to snap uncontrolled against the
retractor housing.
NOTE
If the belt snaps rapidly into the retractor hous-
ing, the automatic locking mechanism may
lock the belt with the buckle against the hous-
ing. This will prevent the belt from being pulled
out with normal force. To free the belt, pull it
strenuously until slight movement is detected,
then release it slowly. This should unlock the
belt and allow it to be withdrawn normally from
the retractor housing.
Operation
4
Operator Compartment
67Operating Instructions-1202 series LP 12028011590US-11/2022 - 04
To Next Page
Loading...
