Linde E30 - Programming and Reading the Service Hour Menu Functions 32 to

Service Training
Section 2.6
Page 86
Batterie OK
*Linde Test Module**
** Version 2.94 **
** Device Ready **
* No Data received *
- Depress the ENTER button to store the new service hours (ES).
- The newly programmed service hours (NS) will appear in the third line of the display.
- After the battery test there will appear
M N B H
E S
N S
* Data end *
2.6.11.1.3 PROGRAMMING AND READING THE SERVICE HOUR MENU FUNCTIONS 32 TO 35
When a combined instrument is replaced in the course of a repair, it may be necessary to store the service
hours of the former combined instrument in the new combined instrument. This is only possible once with
a new combined instrument whose total service hour count is between 9999.7 and 00000.0 hours.
- Connect the diagnostic unit to the truck data connector. The data connector is located behind the left switch
cover at the instrument panel.
- Turn on the key switch.
- Depress the EIN (on) button. If the internal batteries are OK, the following message will appear on the
display
M N B H
E S
- Depress the DATEN NEU (new data) button.
- Enter the menu number.
- The selected menu number (MN) will appear and the current number of service hours (BH).
- The desired number of service hours can be entered with the numeric buttons. The input must have
6 digits (use leading zeros and after the decimal point).
- The programmed service hours (ES) will appear in the second line of the display.
- If an error occurs during the input, the procedure can be quit with any button.