Service Training
Section 2.2
Page 2
2.2.1 DRIVE AXLE REMOVAL
- Remove the mast and the front wheel bolts.
- Jack up and secure the truck.
- Tilt the overhead guard back to the second detent.
- Unscrew the wheel bolts and remove the wheels.
- Loosen the locknut (3) on the parking brake lever (1) and the adjustment nut (2) on the parking brake cable
(4).
- Unhook the parking brake cable (4) at the bottom of the brake shoes (5) and (6).
- Remove one pin retainer (9) on each of the two brake shoes (5) and (6).
- Unscrew the socket head screw (7) at the bearing plates and remove the lever (8) along with the connecting
rod (11).
- Disconnect the cables at the traction motors.
- Disconnect cable connectors 1X7 and 1X8 at the traction motors.
- Disconnect the cable connector for the speed sensor on the left-hand traction motor.
- Disconnect the cable connector for the fan.
- Remove the air duct hose.
- Support the drive axle with a pallet truck and blocks of wood.
- Remove the eight fastening screws on each bearing plate.
- Lower the drive axle.
To Next Page
Loading...
