Linksys WRT 1900AC

WRT 900AC | Setting Up: Advanced 38
• IntheSource IP Address section, select Any IP Address to allow access to
yourDMZdevicefromtheentireInternet,orselectthealternatebuttonand
enter a range of allowed source addresses.
• IntheDestination IP Address section, enter the last three digits of the IP
addressofthedevicethatwillbeintheDMZ.TherestoftheIPaddressis
already completed.
- OR -
If you want to specify the 2-digit MAC address of the device instead of setting up
a DHCP address reservation, you can replace Step 6 with the following steps:
• IntheDestination IP Address section, select MAC Address, then click View DHCP
Client Table. The DHCP Client Table screen opens.
• ClickSelectnexttothedevicethatyouwanttoplaceintheDMZ,thenclick
Close. The corresponding MAC address is copied into the MAC Address field.
• ClickOK.