Lippert Components In-Wall Slide-Out - Component Inspections; Roller, Rack, and V-Roller Checks

Rev: 06.14.2016
Page 10
IN-WALL® Slide-out Service Manual
Floor Rollers
1. Check that the seals are not getting caught in the rollers, which could cause binding of the slide-out.
2. Check for proper roller engagement (Fig. 20):
A. Rollers should not be digging into the floor of the slide-out.
B. Rollers should not spin freely beneath slide-out.
Callout Description
A Motor
B Gear Rack
C Shoe
D V-Roller
Gear Racks
1. Check to make sure the screws in the gear rack are secured flush and not getting caught in the seals
(Fig. 21B).
2. Gear Racks MUST be parallel.
V-Rollers
1. Visually inspect V-roller (Fig. 21D) for obstructions or damage.
Fig. 20
Fig. 21 - Bearing Block Detail
Floor of Unit
Floor of Slide-out
Floor Roller
B
D
C
A