Lippert Components In-Wall Slide-Out User Manual

Rev: 06.14.2016
Page 2
IN-WALL® Slide-out Service Manual
TABLE OF CONTENTS
Safety Information 3
Operation 3
Prior to Operation 3
Extending Slide-out Room 4
Retracting Slide-out Room 4
Controller Overview (B Version) 5
Controller Overview (C2 Version) 6
Motor and Controller Compatibility 7
Motors and Harnesses 8
Resynchronizing the Slide-out Motors 8
Extend and Retract Switch Connections 8
Power and Ground Connections at the Controller 8
Visual Inspections 9
Measurements 9
Floor Rollers 10
Gear Racks 10
V-Rollers 10
Troubleshooting 11
Checking Circuit Breakers 11
Obstructions 11
Debris in the rack 11
Error Codes 11
Electronic Manual Override (Controllers C-1 and C-2 Only) 12
Motor Disengagement Procedure 12
Low Voltage 12
Motor Direction Switches 12
Rewiring Instructions 13
Wiring Color Code Information 13
Motor Replacement 14
Tools Required 14
With Motor Notch (Current Style) 14
Without Motor Notch (Old Style) 16
Assembly Removal Procedure 18
Tools Required 18
Procedure 18
Assembly Installation Procedure 20
Synchronizing The Slide-Out Motors 21
In-Wall® Slide-out assembly 22
In-Wall® Slide-out Controllers 23
In-Wall® Slide-out Motors 24
In-Wall® Slide-out Components 25 - 28

Lippert Components In-Wall Slide-Out Specifications

General

Brand	Lippert Components
Model	In-Wall Slide-Out
Category	Automobile Accessories
Language	English