Lippert Components In-Wall Slide-Out User Manual

Rev: 06.14.2016
Page 20
IN-WALL® Slide-out Service Manual
Assembly Installation Procedure
1. Prepare the slide room and side of the unit for the new install by cleaning the surfaces of any adhesive
residue using a putty knife and a solvent, being careful not to damage the finishes on the unit.
2. Prepare the new system for installation: measure the distance (center to center) from one gear rack to
the next gear rack along the slide column. Write these measurements down.
3. Apply OEM recommended sealant to the entire length of the H-column along the inside edge where it
will contact the side face of the unit.
NOTE: If installing a new assembly, remove the shipping angles before continuing this procedure.
4. Gently slip the system through the opening between the slide room and the side wall opening. Tuck
the gear racks inside the bulb seal attached to the T-molding.
5. Align the bottom lip (alignment flange) of the lower gear rack with the bottom edge of the slide room
(Fig. 41).
6. Push the bottom gear rack tight against the bottom of the slide room and put a screw into each end of
the gear rack.
Fig. 41
Slide Room
Lower Gear Rack
Alignment Flange
Bottom Edge
of Slide Room

Lippert Components In-Wall Slide-Out Specifications

General

Brand	Lippert Components
Model	In-Wall Slide-Out
Category	Automobile Accessories
Language	English