3 Getting Started
5
3 Getting Started
Switching On
The on / off switch is on the right hand side of the casing, just below the
rubber mounting bush.
On power up, the upper display shows a sequence of check messages and
then the Ready message (or Warm Up message - see below).
The lower display shows the total weight recorded when the LR810 was last
turned off.
Warming Up
For best weighing accuracy, the hydraulic fluid in the lift cylinders should be
at normal operating temperature.
If the machine has been standing idle or used only occasionally during the
last 30 minutes, the empty bucket should be lifted a few times. A zero
check should be performed before weighing.
You can ignore the readings on the weight displays as you warm up the
machine.
Initial Warm up Message
If your LR810 has been set up to display an initial warm up message and has
been off for two hours or more, it prompts you to warm up the machine
before starting weighing.
You need to do three lifts before the display shows Check -00-.
Refer to section 8 on how to zero the LR810.
Weight Display Modes
The LR810 provides two modes for displaying weight data:
• Total mode
• Target mode.
To Next Page
Loading...