10 Adding, Subtracting and Recalling
19
Subtracting a Weight
The subtract function subtracts the lifted weight from the short and long
totals for the current product.
This can be used, for example, when a log has been added and then removed
from a truck.
Another example is when only part of a final bucket load of loose material is
required. You can add the full bucket weight and then re-weigh and subtract
the amount remaining in the bucket.
>
>>
>
To subtract a weight
1. Lift the load smoothly until the LR810 beeps and the TRIG light
comes on. (The lower display shows the lifted weight.)
2. While the TRIG light is on, press SUB.
The LR810 subtracts the weight from the long and short totals for the
current product and displays the result.
The information given in the upper display depends on whether you
are in Total mode or Target mode as shown below.
To Next Page
Loading...
