15 Operator Menu Options
28
15 Operator Menu Options
The operator menu provides options for you to change some of the settings
of the LR810.
The settings you can change are:
• Switch between scale 1 and scale 2.
• Switch batch mode on or off.
• Set the clock.
• Clear all long totals.
These functions are described below. A diagram showing the menu options
(menu map) is given on page 32.
(Another option on the menu is Setup, which provides further functions used
at installation time. Setup requires a security code to allow access to these
functions.)
Menu Keys
The same keys are used for all menu options as follows:
• To access the menu, press MENU.
• To accept an option, press ENT.
• To obtain the next menu option, press
≤
or
(shown as ↑↓ on the display).
• To exit the menu, press EXIT then ENT.
• If you do not press a key, the LR810 returns to the Ready state after a
short delay.
Change Scale
If the multiple scale option is enabled in the LR810, you can select Scale 1
or Scale 2.
Scale 1 and Scale 2 allow two different load bearing implements to be used
for lifting (for example, two different types of bucket).
>
>>
>
To change scale
1. When the LR810 is Ready, press MENU.
2. Press
≤
or
to reach the Change Scale option.
To Next Page
Loading...
