43 -
english
DVB
Common Interface Plus Standard (CI Plus)
CI Plus is an advanced development of the DVB Common Interface
Standard. CI Plus slots are in principle downward compatible to the
previous CI-standard, i.e. CA-modules and Smart Cards according to the
past CI-standard can continue to be used in CI Plus slots, as far as the
programme provider permits this.
Software update for CI-Plus capable CA-modules
Every now and then, there will be new system software for your CA-
module software. There are two software update types.
Recommended update:
Information on an available update is displayed. You can either run this
or cancel the procedure. If you do not install the update, the information
will reappear in regular intervals until the update has been installed.
Forced update:
Information on an available update is displayed. The module does not
decode any more until the update has been successfully implemented.
Troubleshooting
The following information can help, if problems should occur when
running a CA-module:
Switch the TV set off to the standby mode. Remove the CA-module from
the TV set. Switch the TV set off completely. Wait a few seconds. Reinsert
the CA-module. Switch the TV set on again.
If errors continue to occur, make a note of the displayed two-digit error
code (only for CI Plus capable CA-modules). Contact your technical cu-
stomer service (see service addresses on page 127).
To Next Page
Loading...
