17
Press ERASE ALL to delete all stored counts. This will not delete reports or images
of the corresponding count, if they were saved to the internal drive.
Customized protocols for specific cell types may be created.
Each counting mode comes with a pre-set Default counting protocol. These
protocols cannot be edited. The default protocols, by design, will provide optimal
results for most cell types, but protocols for specific cell types or applications may
need to be optimized.
To create a new protocol, select the DEFAULT protocol and press SAVE AS.
Rename the protocol and press Save. The newly created protocol will appear in the
list of protocols.
Select a protocol that is not the Default protocol.
Press EDIT. This will activate the arrows for each parameter, turning them black.
Press the arrows to adjust the values of each parameter. Press SAVE AS to change
the protocol name. Press Load to save the edited protocol under the selected name.
To Next Page
Loading...
Need help?
General
