Loop Telecom Loop-V 4200 - Page 86

Appendix C
8-1
Hardware
Install the Loop-V 4200-9 according to instructions in the user manual.
Install plug-in cards into Ports A, B, C, D, E, F, J, and K. E1 cards, T1 cards, or a combination of E1 and T1
cards may be used, but for each port pair, the working port and the protecting port must have the same type
of plug-in cards installed.
Do not install any cards into Port H.
Install a VT-100 terminal via the console port on the front of the Loop-V 4200-9.


A


B

D


C


H


E


F


K


J
Working Port
Protection Port
Working Port
Working Port
Working Port
Protection Port
Protection Port
Protection Port
T.S.I.
TS 01-10
TS 11-20
TS 21-30