Appendix C
8-2
Setting up the TSI Map
Press ‘S’ from the Controller Menu to access the System Setup screen.
LOOP-V 4200-9 === Controller Menu === 17:30:47 01/18/2002
Serial Number: 10070 Connect_port: SUPV_PORT
Version : HW H/W VER.E SW S3.Q4 05/24/2002
Start Time : 15:35:17 06/25/2002 PWR1: active PWR2: active
[Port Status]
A B C D E F H J K
FE1 FE1 FE1 FE1 FE1 FE1 o FE1 FE1
[DISPLAY] [SETUP]
C -> Display System Configuration S -> System Setup
Q -> Alarm Queue Summary P -> Password Setup
I -> Information Summary M -> System Alarm Setup
L -> Firmware Download/Upload
T -> Configuration Download/Upload
V -> Store/Retrieve Configuration
[LOG] [MISC]
U -> Choose a Unit A -> Alarm Cut Off
F -> Log Off [SETUP],[MISC] Menu X -> Clear Alarm Queue
O -> Log On [SETUP],[MISC] Menu Y -> Controller Return to Default
Z -> Controller Reset
K -> Load All Ports Default
>>SPACE key to refresh or enter a command ===>
Select “PORT_BACKUP” by moving the asterisk with the ‘arrow’ keys. Then press ‘ENTER’.
LOOP V4200-9 === System Setup === 09:25:55 07/19/2000
>> Select System_setup Type ? MAP *PORT_BACKUP SYSTEM CLOCK
The System Setup (BACKUP) screen will appear. Use the ‘arrow’ keys and the ‘TAB’ keys to set up the
backup ports as shown below. Then press ‘ESC’ to return to the System Setup screen.
LOOP-V 4200-9 === System Setup ( BACKUP ) === 10:29:09 01/18/2002
ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS
PORT A PORT B PORT C PORT D PORT E PORT F PORT H PORT J PORT K PORT Z
FE1 FE1 FE1 FE1 FE1 FE1 FE1 FE1 INBAND
BACK NONCAS NONCAS NONCAS NONCAS NONCAS NONCAS NONCAS NONCAS
UP ====== ====== ====== ====== ====== ====== ====== ====== ====== ======
BY PORT B PORT D PORT F PORT K
<< Press ESC key to return to previous menu >>
Select “MAP” by moving the asterisk with the ‘arrow’ keys. Then press ‘ENTER’.
LOOP V4200-9 === System Setup === 09:25:55 07/19/2000
>> Select System_setup Type ? *MAP PORT_BACKUP SYSTEM CLOCK
To Next Page
Loading...