Appendix D
9-4
The TCP/IP Properties screen will appear and display the IP address and subnet Mask of the PC you are
using. Note that the sample address here is the same as that displayed in Figure 9-2 . Move to the top of
the screen and left-click your mouse on the Gateway button.
Key in a Gateway address. If you are using the SNMP Card of the Loop-V 4200-9 to download, the Gateway
address will be the IP address of the 4200-9 SNMP card Ethernet port. If you are using the Router card to
download,you must enter the Gateway address of the Router Card’s Ethernet port After keying in the
Gateway address left-click the ADD button with your mouse.
NOTE:
In our sample screen below additional addresses show up in the bottom window of theTCP/IP
screen. Addresses may also show up at this location on your screen. If they do you can safely
ignore them.
To Next Page
Loading...