Appendix D
9-7
Repeat the process for the PC’s IP address. Key in ‘ping’ and the IP address of the PC (192.168.100.206 in
Figure 9-2).
After successfully concluding the Ping tests minimze the TCP/IP window and the Network window.
(If either of these ping tests is unsuccessful check all connections and check that you have entered all IP
addresses properly and that they are in the right domain.)
Go to the Loopterm icon on your screen and double click it to open the Loopterm program. A half-field
Controller Menu will appear as shown below.
LOOP V4200-9 === Controller Menu === 16:17:15 08/18/2003
Serial Number: 10076 Connect_port: SUPV_PORT
Version : HW VER.D SW V3.07 01/01/2003
Start Time : 16:25:08 07/23/2003
[Port Status]
A B C D E F H J K
FE1 FE1 FE1 FE1 FE1 FE1 FE1 o o
[DISPLAY] [SETUP]
C -> Display System Configuration
Q -> Alarm Queue Summary
I -> Information Summary
[LOG] [MISC]
U -> Choose a Unit
F -> Log Off [SETUP],[MISC] Menu
O -> Log On [SETUP],[MISC] Menu
>>SPACE key to refresh or enter a command ===>
Press O to log on. You will be asked for a password. Key it in and press ENTER. The following full-field
Controller Menu will appear. (If you don’t know the password see your system administrator. The default
password for Loop brand products is Loop. If you are using a “no-brand” Loop product, the default password
is 1234.).
LOOP V4200-9 === Controller Menu === 16:17:32 08/18/2003
Serial Number: 10076 Connect_port: SUPV_PORT
Version : HW VER.D SW V3.07 01/01/2003
Start Time : 16:25:08 07/23/2003
[Port Status]
A B C D E F H J K
FE1 FE1 FE1 FE1 FE1 FE1 FE1 o o
[DISPLAY] [SETUP]
C -> Display System Configuration S -> System Setup
Q -> Alarm Queue Summary P -> Password Setup
I -> Information Summary M -> System Alarm Setup
L -> Firmware Download/Upload
T -> Configuration Download/Upload
V -> Store/Retrieve Configuration
[LOG] [MISC]
U -> Choose a Unit A -> Alarm Cut Off
F -> Log Off [SETUP],[MISC] Menu X -> Clear Alarm Queue
O -> Log On [SETUP],[MISC] Menu Y -> Controller Return to Default
Z -> Controller Reset
K -> Load All Ports Default
>>SPACE key to refresh or enter a command ===>
To Next Page
Loading...