Lovibond SD 320 Con - Page 45

45
SD 320_2 05/2015
Menü Parameter Werte Bedeutung
Auto Hold: Automatic measurement processing (only
with Logger = oFF operative)
on Automatic measurement processing
(only with Logger = oFF) Auto Hold
oFF Standard hold function at the push of a
button (only with Logger = oFF)
Auto Power-Off : Automatic device shut-off.
1 - 120 Shut-off delay in minutes. If no button is
pressed and data traffic no longer takes
place through the interface, the device
shuts off automatically after the lapse
of this time
oFF Automatic shut-off deactivated (continu-
ous operation)
Background lighting
oFF No lighting
5 - 120 Automatic shut-off of lighting after 5 -
120 s (factory setting: 5 s)
on Lighting always on
Universal output

SEr Serial interface activated
dAC Analogue output activated
oFF Interface and analogue output off ->
minimal power consumption
Serial interface (only with

= )
01.11 - 91 Base address of the unit for serial inter-
face communication
Analogue output (only with

= )
0.0000 µS/cm
... 1000 mS/cm
Input of the measurement at which the
analogue output should output 0V, e.g.
with 0.0000 µS/cm
0.0000 µS/cm
... 1000 mS/cm
Input of the measurement at which the
analogue output should output 1V, e.g.
with 100.0 mS/cm
(**) If logger is running parameters marked with (**) cannot be called.