LS Industrial Systems G3L-RUEA - High Speed Link Communication Status Flag; Gmwins High Speed Link Setting

Chapter 6. Communication Function
6-2
6.1.2 High Speed Link communication status flag
1) High Speed Link information function
It is used to check whether the reliability of the data sent out or received from the remote station
and the user can use this information for maintenance and emergency by combining the data sent
out or received through High Speed Link as a keyword form when programming.
High Speed Link information
Classification RUN-LINK
LINK-Trouble
LINK_
TROUBLE
TRX status
TRX_MODE
Operation
mode
DEV_MODE
error
DEV_ERROR
HS Link status
HS_STATE
Information
type
Entire
information
Entire
information
Individual
information
Individual
information
Individual
information
Individual
information
Key word
name
(=HS Link
no.
1,2,3,4 )
_HSRLINK _HSLTRBL
_HSTRX[n]
(n=individual
parameter no.
0~63 )
_HSMOD[n]
(n= individual
parameter no.
0~63 )
_HSERR[n]
(n= individual
parameter no.
0~63 )
_HSSTATE[n]
(n= individual
parameter no.
0~63 )
Data type BIT BIT BIT-ARRAY BIT-ARRAY BIT-ARRAY BIT-ARRAY
Monitoring available available available available available available
Used for
programming
available available available available available available
(If GRL-TR4A’s module is connected, the high flag doesn’t operate. Be careful when programming)
6.1.3 GMWIN’s High Speed Link setting
1) GMWIN’s project and Link parameter
If you select the High Speed Link parameter on the GMWIN project basic screen and enter High
Speed Link parameter basic screen, each item shows up.
High Speed Link parameter basic screen
The above menu shows up, if selecting [Parameter] - [Link Parameters].